Furukawa Electric Power Systems

F-CO Products

Main Content starts

Electrical Insulation Materials

F-CO Tape No.2

photo of F-CO Tape No.2
F-CO Tape No.2

F-CO TAPE No.2 is a self-bonding tape which is used for electrical insulation with easy application.

F-CO TAPE No.2 won international recognition as a good insulating tape for more than 30 years. F-CO TAPE No.2 has excellent adhesiveness and insulation property.

Meet to JCAA(Note 1) D 004

(Note 1)JCAA:Japan Power Cable Accessories AssociationBack to Main Content

Use

100V to 69kV cables

  • To insulate the end of high voltage cables, electric wires and cable joints
  • To repair the cracks of insulator of cables for high voltage and electric wires
  • To protect insulation cover and clamp cover from water and slip down
  • (Note) Primary electrical insulation for splicing cable from 600V to 69kV on all solid dielectric cables.
  • (Note) Primary insulation for building stress cones on cables up to 36kV on all solid dielectric cables.

Structure/Material

fig of F-CO Tape No.2

Properties

Item Property
Tensile strength
N/mm2
Normal 2 or over
After heat aging 2 or over
Elongation % Normal 350 or over
After heat aging 300 or over
Volume resistivity
Ω-cm(20°C)
1×1015 or over
AC breakdown strength
kV/mm
30 or over
Shear adhesive strength
N/20mm
20 or over
Ozone resistance Good
Tracking resistance Good
Water resistance Good

(Note)These are measured values and not guaranteed.

Size/Packing unit

Thickness(mm) Width(mm) Length(m) Packing unit(rolls)
0.5 20 5 100
0.5 20 10 100

How to use

  • Wind the tape half-lapped, with the adhesive side inside, stretching it evenly to the extent that its original width is reduced to about 10% (its width decreases by 1-2mm).
  • Do not stretch the tape too much. In cold season, warm up the tape (+5°C+30°C) before application.
(Note)To improve the product, the specifications may be changed without any notice.

Top of Page

Main Content ends